Omron VARISPEED E7 User Manual page 243

Param-
eter
Number
Operation selection when dig-
o2-06
ital operator is disconnected
Cumulative operation time
o2-07
setting
Cumulative operation time
o2-08
selection
o2-09 Initialize Mode
o2-10 Fan operation time setting
o2-12 Fault trace initialize
o2-14 Energy monitor initialize
o2-15 HAND key function selection
6
Monitor Selection (o1-01)
Using parameter o1-01 the third monitor item that is displayed in drive mode can be selected. This function
has no effect on the optional LCD-operator (JVOP-160-OY).
Monitor Display when the Power Supply is Turned ON (o1-02)
Using parameter o1-02 the monitor item (U1-
power supply is turned ON can be selected.
Changing Frequency Reference and Display Units o1-03)
Set the Digital Operator frequency reference and display units using parameter o1-03. The setting in o1-03
will affect the display units of the following monitor items:
U1-01 (Frequency Reference)
•
U1-02 (Output Frequency)
•
U1-05 (Motor Speed)
•
U1-20 (Output Frequency after Soft Start)
•
d1-01 to d1-04 (Frequency references)
•
104
6-
Name
Sets the operation when the Digital Operator is dis-
connected.
0: Disabled (Operation continues even if the Dig-
ital Operator is disconnected.)
1: Enabled (OPR is detected at Digital Operator
disconnection. Inverter output is switched off,
and fault contact is operated.)
Sets the cumulative operation time in hour units.
Operation time is calculated from the set values.
0: Cumulative time when the Inverter power is on.
(All time while the Inverter power is on is accu-
mulated.)
1: Cumulative Inverter run time. (Only Inverter
output time is accumulated.)
2: Europe
5: PV-E Spec
Set the initial value of the fan operation time using
hour units.
The operation time accumulates from the set value.
0: Disable
1: Initialize (= zero clear) after setting "1" o2-12
will be returned to "0"
Resets the monitor parameter U1-29 and U1-30
back to zero.
0: No change
1: Reset to zero
If set to 0 the HAND button on the digital operator
is disabled and the drive will not enter the HAND
mode and start to run when the HAND button is
pressed.
0: HAND button disabled
1: HAND button enabled
This function is effective only when the optional
HOA operator (JVOP-162) is used.
Setting
Description
Range
0 or 1
65535
0 or 1
2 or 5
65535
0 or 1
0 or 1
0 or 1
) that is to be displayed on the Digital Operator when the
Change
Factory during Access
Setting Opera- Level
tion
0 No A
0 to
0 No A
0 No A
2 No A
0 to
0 No A
0 No A
0 No A
0 No A