Programming (Example 4) - Siemens SINUMERIK 808D User Manual

13.5

Programming (Example 4)

Ma chining requirements
Wo rkpiece drawing (unit: mm)
Te chnical requirements
● The arc transition must be smooth, without lapping.
● The cutting trace must be even.
● The sharp edges must be rounded.
Bl ank data
Blank material: Cube aluminum
Blank length: 100 mm
Blank width: 80 mm
Blank height: 60 mm (machining length: 46 mm; clamping length: 10 mm)
R e quired tool
To ol type
Face milling tool
End milling tool
End milling tool
Drilling tool
Tapping tool
N o te
When programming in ISO mode, you need to set the H numbers of T1 to T5 as 1 to 5 respectively in the tool list;
•
Cut the workpiece manually after machining is over.
•
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
To ol number To ol diameter
DIN ISO (mm)
T1D1 T1H1 50
T2D1 T2H2 12
T3D1 T3H3 4
T4D1 T4H4 5
T5D1 T5H5 6
R o ughing
Speed Feedrate
1500 600
4000 600
4000 600
1200 100
600 600
Fi nishing
Speed Feedrate
2500 600
4000 600
4000 600
1200 100
600 600
267