Siemens SINUMERIK 808D User Manual page 260

260
51. Press this key to enter a new line.
Continue to enter the following program blocks and then press this key again:
X36 Y24.1
MCALL
G0 Z100 M9
T8 D1
M6
G0 Z100
S500 M3 M8
52. Open the window for CYCLE84 through the following softkey operations:
→
Enter the desired parameters as follows:
53. Press this softkey to call this cycle modally.
54. Confirm your input and open the cycle programming window.
55. Proceed through the steps described earlier to copy the entire program blocks for HOLES2
and paste it in the line after the above program blocks.
56. Place the cursor on the end-of-block character of HOLES2 with the scursor keys and press
this key to enter a new line.
Continue to enter the following program blocks:
X36 Y24.1
MCALL
G0 Z100
M9
M05
M30
Then you can proceed with the operations for "program simulation and execution
(Page 278)".
→
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017