Siemens SINUMERIK 808D User Manual page 240

240
Enter the desired parameters as follows:
24. Press this softkey to confirm your input and open the cycle programming window.
Enter the following program block:
S4500 M3
25. Proceed through the steps described earlier to copy the entire program block for POCKET4
and paste it in the line after the above blocks.
26. Press this softkey to open the window for POCKET4 again. Change the values of "MID",
"FFP1", "FFD" and "VARI" to "5", "400", "200" and "2" respectively.
27. Press this softkey to accept the change and open the cycle programming window.
28. Press this key to enter a new line.
Continue to enter the following program blocks and then presss this key again:
G0 Z100 M8
T3 D1
M6
S5000 M3 M8
G0 X0 Y0
29. Open the window for CYCLE81 through the following softkey operations:
→
Enter the desired parameters as follows:
30. Press this softkey to call this cycle modally.
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017