Siemens SINUMERIK 808D User Manual page 146

Example: Tool definition
The following example is suitable for testing the parameterization of the TRACYL cylinder transformation:
Program code
Tool parameters
Number (DP)
$TC_DP1[1,1]=120
$TC_DP2[1,1]=0
Program code
Geometry
$TC_DP3[1,1]=8.
$TC_DP4[1,1]=9.
$TC_DP5[1,1]=7.
Program code
Geometry
$TC_DP6[1,1]=6.
$TC_DP7[1,1]=0
$TC_DP8[1,1]=0
$TC_DP9[1,1]=0
$TC_DP10[1,1]=0
$TC_DP11[1,1]=0
Program code
Wear
$TC_DP12[1,1]=0
Example: Making a hook-shaped groove
Activate cylinder surface transformation:
Required tool: T1 milling tool, radius=3 mm, edge position=8
Program code
N10 T1 D1 G54 G90 G94
F1000
N20 SPOS=0
N30 SETMS(2)
N40 M3 S2000
N50 DIAMOF
N60 G0 X23 Z105
N70 TRACYL (20)
N80 G19
146
Comment
Meaning
Tool type (Milling tool)
Cutting edge position (Only for turning tools)
Comment
Length compensation
Length offset vector (Calculation acc. to type and plane)
Comment
Radius
Tool radius
Slot width b for slotting saw, rounding radius for milling tools
Projection k (For slotting saw only)
Angle for taper milling tools
Comment
Length and radius compensation
Remaining parameters to $TC_DP24=0 (Tool base dimension/adapter)
Comment
; Tool selection, clamping compensation
; Approach the starting position
; Set the second spindle as the main spindle
; Run the spindle
; Change the diameter dimensioning to radius dimensioning
; Activate cylinder surface ;transformation
; Plane selection
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017