A.2.1.4 Face Milling - Siemens SINUMERIK 808D User Manual
Programming and operating manual (milling)
Hide thumbs
Also See for SINUMERIK 808D:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
A.2.1.4
Face milling
Fu n ctionality
Use this function to prepare a blank for the subsequent machining without creating a special part program.
Op e rating sequence
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
1.
Select the desired operating area.
2.
Switch to "JOG" mode.
3.
Open the face milling window.
4.
Move the cursor keys to navigate in the list and enter the desired values for the selected
parameters (see table below for the parameter descriptions).
5.
Confirm your entries with the appropriate key.
6.
Select the cutting path of the tool during machining.
7.
Use this softkey to confirm your settings. The system now automatically creates the part
program.
8.
Press this key on the MCP to run the part program.
291
Advertisement
Table of Contents
