Siemens SINUMERIK 808D User Manual page 239

Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
→
Enter the desired parameters as follows:
18. Press this softkey to confirm your input and open the cycle programming window.
Enter the following program blocks:
AROT Z90
_END:
REPEAT _ANF _END P=3
ROT
S4500 M3
_ANF1:
19. Proceed through the steps described earlier to copy the entire program block for POCKET3
and paste it in the line after the above program blocks.
20. Press this softkey to open the window for POCKET3 again. Change the values of "MID",
"FFP1", "FFD" and "VARI" to "5", "400", "200" and "2" respectively.
21. Press this softkey to accept the change and open the cycle programming window.
22. Press this key to enter a new line.
Continue to enter the following program blocks and then press this key again:
AROT Z90
_END1:
REPEAT _ANF1 _END1 P=3
ROT
G0 Z100
23. Open the window for POCKET4 through the following softkey operations:
→
→
→
239