Siemens SINUMERIK 808D User Manual page 269

Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
Enter the desired parameters as follows:
7. Press this softkey to confirm your input and open the cycle programming window.
Continue to enter the following program block:
S2500 M3
8. Press this softkey to return to the program editor window.
9. Move the cursor to "C" in the line for CYCLE71 with the cursor keys and press this softkey
to insert a marker.
10. Use the cursor keys to select the entire program block for CYCLE71. Press this softkey to
copy the selection to the buffer memory.
11. Place the cursor in the last empty line and press this softkey to paste the content of the
buffer memory into the empty line.
12. Press this softkey to open the window for CYCLE71 again. Change the values of "FALD"
and "FFP1" to "0" and "400" respectively.
13. Move the cursor to the input field of "VARI" and press this key to change the value to "32".
14. Press this softkey to accept the change.
15. Continue to enter the following program blocks and then press this key again:
G0 Z100 M9
T2 D1
M6
G0 Z100
S4000 M3 M8
16. Open the window for CYCLE76 through the following softkey operations:
→ →
269