Setting Up The Workpiece - Siemens SINUMERIK 808D User Manual
Programming and operating manual (milling)
Hide thumbs
Also See for SINUMERIK 808D:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
10.4
Setting up the workpiece
10.4.1
Measuring the workpiece
Ove rview
You must select the relevant offset panel (for example, G54) and the axis you want to determine for the offset first.
Before measuring, you can start the spindle by following the steps in Section "Activating the tool and the spindle (Page 23)".
Op e rating sequence
Wo rkpiece edge measurement
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
1.
Select the machining operating area.
2.
Switch to "JOG" mode.
3.
Open the window for workpiece measurement.
4.
Press this vertical softkey to open the window for measurement at the workpiece edge.
5.
Press this softkey to measure in the X direction.
6.
Traverse the tool, which has been measured previously, to approach the workpiece in the X
direction.
7.
Switch to handwheel control mode.
8.
Select a suitable override feedrate, and then use the handwheel to move the tool to scratch
the required workpiece edge.
57
Advertisement
Table of Contents
