A.2.1.3 Setting The Relative Coordinate System (Rel) - Siemens SINUMERIK 808D User Manual
Programming and operating manual (milling)
Hide thumbs
Also See for SINUMERIK 808D:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
A.2.1.3
Setting the relative coordinate system (REL)
Op e rating sequence
290
1.
Select machining operating area.
2.
Switch to "JOG" mode.
3.
Press this softkey to switch the display to the relative coordinate system.
4.
Use the cursor keys to select the input field, and then enter the new position value of the
reference point in the relative coordinate system.
5.
Use this key to activate the values after each entry.
You can use the corresponding vertical softkeys to set the reference point to zero.
Sets the X axis to zero
Sets the Y axis to zero
Sets the Z axis to zero
Sets the spindle to zero
Sets all axes to zero
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
Advertisement
Table of Contents
