Siemens SINUMERIK 808D User Manual page 160

D TB (dwell time)
The dwell time to the final drilling depth (chip breakage) is programmed under DTB in seconds.
Programming example 1: Drilling_counterboring
The program machines a single hole of a depth of 27 mm at position X24 Y15 in the XY plane with cycle CYCLE82.
The dwell time programmed is 2 s, the safety clearance in the drilling axis Z is 4 mm.
N10 G0 G17 G90 F200 S300 M3
N20 D1 T10 Z110
N30 X24 Y15
N40 CYCLE82 (110, 102, 4, 75, , 2)
N50 M02
Programming example 2: Drilling_counterboring
Proceed through the following steps:
1.
2.
3.
4.
160
Select the desired operating area.
Open the vertical softkey bar for available drilling cycles.
Press this softkey from the vertical softkey bar.
Press this softkey to open the window for CYCLE82. Parameterize the cycle as desired.
; Specification of technology values
; Approach retraction plane
; Approach drilling position
; Cycle call with absolute final drilling
depth and safety clearance
; End of program
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017