Siemens SINUMERIK 808D User Manual page 61

Se tting the time counter
Op e rating sequence
Pa rameters in the window for timers and workpiece counters
① The total number of workpieces produced (total actual)
② The number of workpieces required (workpiece setpoint)
③
The number of all workpieces produced since the starting time
④
The total run time of NC programs in "AUTO" mode and the run time of all programs between NC start and end of
program/RESET. The timer is set to zero with each power-up of the control system.
⑤
The run time of the selected NC program in seconds
The default value is 0 each time a new NC program starts up. You can set MD27860 to ensure that this value will be
deleted even if there is a jump to the beginning of the program with GOTOs or in the event of ASUPs (used for tool
change in "JOG" and "MM+" modes) and PROG_EVENTs starting.
⑥
Processing time in seconds
⑦ The time since the last system power-up with default values ("cold restart") in minutes
⑧ The time since the last normal system power-up ("warm restart") in minutes
N o te
The timer is automatically reset to zero in case of a control power-up with default values.
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
1. Select the offset operating area.
2. Open the setting data window.
3. Open the time counter window.
4. Position the cursor bar in the input fields to be modified and enter the values (see table
below for the parameter descriptions).
5. Use this key or move the cursor to confirm your entries.
61