Entering/Modifying The Setting Data - Siemens SINUMERIK 808D User Manual

3.
4.
10.5

Entering/modifying the setting data

En tering/modifying the setting data
Op e rating sequence
1.
2.
3.
4.
5.
Pa rameters in the setting data window
① ② A limitation of the spindle speed in the maximum (G26)/minimum (G25) fields can only be performed within the
/
limit values defined in the machine data.
③ For thread cutting, a start position for the spindle is displayed as the start angle. A multiple thread can be cut by
changing the angle when the thread cutting operation is repeated.
60
Use the cursor keys to position the cursor bar in the input fields to be modified and enter the
values.
Confirm your entries. The changes to the workpiece offsets are activated immediately.
Select the offset operating area.
Open the setting data window.
Open the window for setting the general data.
Position the cursor bar in the input fields to be modified and enter the values (see table
below for the parameter descriptions).
Use this key or move the cursor to confirm your entries.
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017