Executing From External (Through Ethernet Connection) - Siemens SINUMERIK 808D User Manual

10.10.2.2 Ex ecuting from external (through Ethernet connection)
Pre requisites:
● An Ethernet connection has been established between the control system and the computer.
● A network drive (which includes the part program to be executed) has been created and connected.
Proceed as follows to execute a part program from external through the Ethernet connection:
10.10.2.3 Transferring from external (through Ethernet connection)
Pre requisites:
● An Ethernet connection has been established between the control system and the computer.
● A network drive (which includes the part program to be transferred) has been created and connected.
Proceed as follows to transfer a part program from external through the Ethernet connection:
70
1. Select the program management operating area.
2. Press this softkey to view the network drive(s) created.
3. Select the desired network drive (which includes the part program to be executed) and
press this key to open it.
4. Select the program file you desire to execute.
5. Press this softkey and the system automatically switches to "AUTO" mode in the machining
operating area. The program is transferred to the buffer memory on the control system and
then displayed in the following window:
6. If desired, you can use this softkey to specify how you want the program to be executed.
For more information of the program control, refer to Section "Program control functions
(Page 53)".
7. Press this key to execute the program. The program is reloaded continuously.
Either at the end of the program or after pressing this key, the program is automatically
removed from the control system.
1. Select the program management operating area.
2. Press this softkey to view the network drive(s) created.
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017