Siemens SINUMERIK 808D User Manual page 256

256
21. Press this key to enter a new line.
Continue to enter the following program blocks and then press this key again:
G0 Z100 M9
T5 D1
M6
G0 Z100
M3 S5000 M8
22. Open the window for SLOT2 through the following softkey operations:
→
Enter the desired parameters as follows:
23. Press this softkey to confirm your input and open the cycle programming window.
Continue to enter the following blocks:
G0 Z100 M9
T2 D1
M6
G0 Z100
X-5 Y0
S3500 M3 M8
24. Press this key to enter a new line.
25. Open the window for CYCLE72 through the following softkey operations:
→
26. Enter the name of the contour subroutine in "KNAME", for example, "CON1".
27. Press this softkey to open the program editor window again and enter the program blocks
for the external contour:
G17 G90 DIAMOF
G1 X7 Y-5
G1 Y61.35
G2 X13.499 Y86 I=AC(57) J=AC(61.35)
G1 X63 RND=2
Y0
X2
M2
→
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017