Mitsubishi M80 series Connection And Set Up Manual page 491

M800S/M80 Series Connection and Setup Manual
29 SRAM Open Parameter Screen
Menu when inputting the display format
Menu
W/ DEC
Change the display format to the decimal format with sign.
sign
W/O DEC
Change the display format to the decimal format without sign.
sign
Change the display format to the hexadecimal format.
HEX
Change the display format to the BIT format.
BIT
BCD Change the display format to the BCD format.
Enable
Change whether to show the group detail screen to the users.
display
Cancel
Change whether the input protection check is valid or not.
protect
Line
Delete a group of the line where a cursor is placed.
clear
Line
Copy the data of a line where a cursor is placed.
copy
Writes the contents of the data copied (one line) into the line where the cursor is placed.
If the data of the line is changed after [Line copy] is pressed, the data before change will be written when
Line
paste pasting it.
Once the line is copied, it can be pasted many times until new area is copied.
Clears all allocation of the parameter in the SRAM open parameter screen.
All
clear (Note) Data of the group detail will not be cleared.
When parameter No. is set and [INPUT] key is pressed, the group will be displayed with the set parameter
Group
No. set at the top of the group.
search
A cursor moves to the line of the target group.
The group detail screen corresponding to the group where a cursor is placed will be displayed.
Group
When the group information, where a cursor is placed, is not set, it will be invalid.
details
IB-1501269-F
Details
454