Install User Cycle - Mitsubishi M80 series Connection And Set Up Manual

M800S/M80 Series Connection and Setup Manual
18 Setting Up with M80/M800S SETUP INSTALLER

18.5 Install User Cycle

Carry out the procedures of this section to register user cycle. When you do not use user cycle, there is no need to carry
out the procedure.
(1) Push the [Custom Cycle] menu.
-> The screen is changed to user cycle installation screen.
(2) Push the [Install] menu.
(3) When a confirmation screen appears, push the [Yes] menu.
(Note) Do not power OFF during installation.
(4) When installation is finished, "Installation completed" appears.
(Note 1) To uninstall the user cycle, push the [Install] menu instead of [Uninst] in the step (2).
(Note 2) The size of user cycle must be 30MB or less. If it exceeds 30MB, the following message appears and the
installation fails.
"Installation Error. Please check the file size."
(Note 3) Installation or uninstallation is not executed when the [Yes] menu is pressed continuously after the previous
installation or uninstallation operation. Push
procedure again.
IB-1501269-F
Return key to return to the initial screen and start the
354