Writing A Plc Program With Gx Developer - Mitsubishi M80 series Connection And Set Up Manual

M800S/M80 Series Connection and Setup Manual
20 PLC Program Writing

20.6 Writing a PLC Program with GX Developer

(Note)This operation is for performing writing in the temporary storage area of CNC (RAM inside CNC). The temporary
storage area (RAM inside CNC) does not hold data after the power is turned OFF. If the data need to be held even after
the power OFF, write the sequence program in ROM inside CNC following the procedure described in "Writing a PLC
Program to ROM with GX Developer".
[Operation procedure]
(1) Perform the following operation with GX Developer to start the operation screen.
[Online] -> [Write to PLC...]
(2) Select a sequence program file for writing in the [File selection] tab of the screen below and click [Execute].
RUN/STOP for PLC can be commanded on [Remote operation...] of "Related functions".
(Note) Only "Program memory/Device memory" is valid for "Target memory".
Do not carry out the setting for other tabs than [File selection] ([Device data], [Program], [Common],
[Local]).
IB-1501269-F 370