M800S/M80 Series Connection and Setup Manual
20 PLC Program Writing
20.5.3 Setting the Number of Common Pointer Points
The number of common pointer points for each sequence program must be set for creating the sequence program with
the multi-program method. This operation is required every time when a new project is created, and the parameter file
must be written to the CNC controller.
(Note)
If this operation is not performed, the number of common pointer points will be the initial value.
(1) Select the tab "PLC system".
(2) Input the value for "Common pointer No." on the screen below and click [End].
IB-1501269-F
368