Table of Contents
Advertisement
Description
Redirect policies can contain multiple destinations. Each destination is assigned an initial or base
priority which describes its relative importance within the policy. If more than one destination is
specified, the destination with the highest effective priority value is selected.
Default
100
Parameters
priority — The priority, expressed as a decimal integer, used to weigh the destination's relative
snmp-test
Syntax
snmp-test test-name
Context
config>filter>redirect-policy>destination
Description
This command enables the context to configure SNMP test parameters.
Default
none
Parameters
test-name — specifies the name of the SNMP test. Allowed values are any string up to 32 characters
oid
Syntax
oid oid-string community community-string
Context
config>filter>redirect-policy>destination>snmp-test
Description
This command specifies the OID of the object to be fetched from the destination.
Default
none
Parameters
oid-string — Specifies the object identifier (OID) in the OID field.
community community-string — The SNMP v2 community string or the SNMP v3 context name
used to conduct this SNMP test.
return-value
Syntax
return-value return-value type return-type [disable | lower-priority priority | raise-priority
priority]
Context
config>filter>redirect-policy>destination>snmp-test
Description
This command specifies the criterion to adjust the priority based on the test result. Multiple criteria
can be specified with the condition that they are not conflicting or overlap. If the returned value is
7450 ESS OS Router Configuration Guide
importance within the policy.
Values
1 — 255
long composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
Filter Policies
Page 397
Advertisement
Table of Contents
