Table of Contents
Advertisement
Configuration Commands
Parameters
lns-group-id — Specifies the LNS group ID.
local-address
Syntax
local-address ip-address
no local-address
Context
config>router>l2tp>group>tunnel
Description
This command configures the local address.
Parameters
ip-address — Specifies the IP address used during L2TP authentication.
local-name
Syntax
local-name host-name
no local-name
Context
config>router>l2tp>group
config>router>l2tp>group>tunnel
Description
This command creates the local host name used by this system for the tunnels in this L2TP group
during the authentication phase of tunnel establishment. It can be used to distinguish tunnels.
The no form of the command removes thename from the configuration.
Default
local-name
Parameters
host-name — Specifies the host name, up to 64 characters in length, that the router will use to identify
max-retries-estab
Syntax
max-retries-estab max-retries
no max-retries-estab
Context
config>router>l2tp>group
config>router>l2tp>group>tunnel
Description
This command configures the number of retries allowed for this L2TP tunnel while it is established,
before its control connection goes down.
The no form of the command removes the value from the configuration.
Default
no max-retries-estab
Page 92
Values
1..4
itself during L2TP authentication.
Default
no local-name
7450 ESS OS Router Configuration Guide
Advertisement
Table of Contents
