Alcatel-Lucent 7450 ESS OS Configuration Manual page 125

Description This command configures the MTU for the nodes to use to send packets on the link.
Default
no mtu — The MTU option is not sent in the router advertisement messages.
Parameters
mtu-bytes — Specify
other-stateful-configuration
Syntax [no] other-stateful-configuration
Description This command sets the "Other configuration" flag. This flag indicates that DHCPv6lite is available
for autoconfiguration of other (non-address) information such as DNS-related information or
information on other servers in the network. .
Default
no other-stateful-configuration
prefix
Syntax [no] prefix [ipv6-prefix/prefix-length]
Context config>router>router-advert>if
Description
This command configures an IPv6 prefix in the router advertisement messages. To support multiple
IPv6 prefixes, use multiple prefix statements. No prefix is advertised until explicitly configured using
prefix statements.
Default none
Parameters ip-prefix — The IP prefix for prefix list entry in dotted decimal notation.
prefix-length — Specifies a route must match the most significant bits and have a prefix length.
autonomous
Syntax [no] autonomous
Context config>router>router-advert>if>prefix
Description This command specifies whether the prefix can be used for stateless address autoconfiguration.
7450 ESS OS Router Configuration Guide
the MTU for the nodes to use to send packets on the link.
Values 1280 — 9212
Values ipv4-prefix
ipv4-prefix-length
ipv6-prefix
ipv6-prefix-length
Values
1 — 128
IP Router Configuration
a.b.c.d (host bits must be 0)
0 — 32
x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
0 — 128
Page 125