Alcatel-Lucent 7450 ESS OS Configuration Manual page 107

Parameters policy-id — Specifies an existing CPU protection policy.
delayed-enable
Syntax delayed-enable seconds
no delayed-enable
Context config>router>if
Description
This command creates a delay to make the interface operational by the specified number of seconds
The value is used whenever the system attempts to bring the interface operationally up.
Parameters
seconds — Specifies a delay, in seconds, to make the interface operational.
local-proxy-arp
Syntax [no] local-proxy-arp
Context config>router>interface
Description This command enables local proxy ARP on the interface.
Default
no local-proxy-arp
ldp-shortcut
Syntax [no] ldp-shortcut
Context config>router
Description
This command enables the resolution of IGP routes using LDP LSP across all network interfaces
participating in the IS-IS and OSPF routing protocol in the system.
When LDP shortcut is enabled, LDP populates the routing table with next-hop entries corresponding
to all prefixes for which it activated an LDP FEC. For a given prefix, two route entries are populated
in the system routing table. One route corresponds to the LDP shortcut next-hop and has an owner of
LDP. The other route is the regular IP next-hop. The LDP shortcut next-hop always has preference
over the regular IP next-hop for forwarding user packets and specified control packets over a given
outgoing interface to the route next-hop.
All user and specified control packets for which the longest prefix match in RTM yields the FEC
prefix will be forwarded over the LDP LSP.
When an IPv4 packet is received on an ingress network interface, a subscriber IES interface, or a
regular IES interface, the lookup of the packet by the ingress IOM will result in the packet being sent
labeled with the label stack corresponding to the NHLFE of the LDP LSP when the preferred RTM
entry corresponds to an LDP shortcut.
7450 ESS OS Router Configuration Guide
Values
1 — 255
Values
1 — 1200
IP Router Configuration
Page 107