Table of Contents
Advertisement
Description
This command configures DSCP name to FC mapping.
Parameters
dscp-name — Specifies the DSCP name.
fc-name — Specifies the forward class name.
triggered-policy
Syntax
triggered-policy
no triggered-policy
Context
config>router
Description
This command triggers route policy re-evaluation.
By default, when a change is made to a policy in the config router policy options context and then
committed, the change is effective immediately. There may be circumstances when the changes
should or must be delayed; for example, if a policy change is implemented that would affect every
BGP peer on a 7450 ESS router, the consequences could be dramatic. It would be more effective to
control changes on a peer-by-peer basis.
If the triggered-policy command is enabled, and a given peer is established, and you want the peer to
remain up, in order for a change to a route policy to take effect, a clear command with the soft or soft
inbound option must be used; for example, clear router bgp neighbor x.x.x.x soft. This keeps the
peer up, and the change made to a route policy is applied only to that peer or group of peers.
single-sfm-overload
Syntax
single-sfm-overload [holdoff-time holdoff-time]
no single-sfm-overload
Context
config>router
Description
This command, if enabled, will cause the OSPF for the service to enter an overload state when the
node only has a single SFM functioning.
The no form of this command causes the overload state to be cleared.
Default
no single-sfm-overload
Parameters
holdoff-time — This parameter specifies the delay between the detection of a single SFM and
7450 ESS OS Router Configuration Guide
Values
be, ef, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cp9, cs1, cs2, cs3, cs4, cs5, nc1, nc2, af11,
af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, cp11, cp13, cp15,
cp17, cp19, cp21, cp23, cp25, cp27, cp29, cp31, cp33, cp35, cp37, cp39, cp41,
cp42, cp43, cp44, cp45, cp47, cp49, cp50, cp51, cp52, cp53, cp54, cp55, cp57,
cp58, cp59, cp60, cp61, cp62, cp63
Values
be, l2, af, l1, h2, ef, h1, nc
enacting the overload state.
Values
1— 600 seconds
Default
0 seconds
IP Router Configuration
Page 81
Advertisement
Table of Contents
