Alcatel-Lucent 7450 ESS OS Configuration Manual page 443

exit
Version 9 and Verison 10 Templates
If the collector is configured to use either version 9 or 10 formats, the flow data is sent to the
designated collector using one of the pre-defined templates. The template used is based on the type
of flow for which the data was collected(IPv4, IPv6, or MPLS), and the configuration of the
template-set parameter. The following table indicates the relationship between these values and the
corresponding template used to export the flow data.
Table 13: Template-Set
Traffic type
IPv4
IPv6
MPLS
Basic IPv4 Template:
0 IPv4 Src Addr (8)
0 IPv4 Dest Addr (12)
0 IPv4 Nexthop (15)
0 BGP Nexthop (18)
0 Iingress Interface (10)
0 Egress Interface (14)
0 Packet Count (2)
0 Byte Count (1)
0 Start Time (22)
0 End Time (21)
0 Flow Start Milliseconds (152)
0 Flow End Milliseconds (153)
0 Src Port (7)
0 Dest Port (11)
0 TCP control Bits (Flags) (6)
0 IPv4 Protocol (4)
0 IPv4 TOS (5)
0 IP version (60)
0 ICMP Type & Code (32)
0 BGP Source ASN (16)
0 BGP Dest ASN (17)
0 Source IPv4 Prefix Length (9)
0 Dest IPv4 Prefix Length (13)
MPLS-IPv4 Template:
0 IPv4 Src Addr (8)
7450 ESS OS Router Configuration Guide
Basic MPLS-IP
Basic IPv4 MPLS-IPv4
Basic IPv6 MPLS-IPv6
Basic MPLS MPLS-IP
Cflowd
Page 445