Secondary Gear Shim Adjustment; Backlash - Suzuki Madura GV700GL Service Manual

4·11 SHAFT DRIVE
• After the bearing pre-load has been adjusted
to specification, remove the nut.
• Clean and degrease the threaded parts of driven
bevel gears shaft and nut, and apply a small
quantity of THREAD LOCK SUPER "1363A"
to the threads of the nut and tighten it to the
specified torque.
99104 · 32030 Thread lock super "1363A"
90- 110 N·m
Tightening torque (9.0 - 11.0 kg-m)
(65.0- 79.5 lb-ft)
• Bend the collar of the nut over into the notch in
the secondary driven bevel gear shaft.
SECONDARY GEAR SHIM ADJUSTMENT
BACKLASH
• Install the secondary drive bevel gear shim
removed during disassembly into the shim seat.
• Install the secondary drive bevel gear assembly
into the secondary gear case.
• Install the secondary driven bevel gear shims
removed during disassembly onto the secondary
driven bevel gear housing.
NOTE:
Do not install the 0-ring at this point. 0-ring
is installed after backlash and tooth contact
are correct.
• Install the secondary driven bevel gear assembly
into the secondary gear case and tighten the four
bolts to the specified torque.
CAUTION:
The secondary driven bevel gear assembly
must be installed with "UP" mark facing
upward as shown in Fig.
Tightening torque
18-28 N-m
(1.8- 2.8 kg-m)
(13.0 - 20.0 lb-ft)