Suzuki Madura GV700GL Service Manual page 76

CRANKCASE-CRANKSHAFT
BEARING SELECTION
• Inspect each bearing of upper and lower crank-
cases for any damage.
• Place plastigauge on each crankshaft journal in
the usual manner.
NOTE:
Do not place the plastigauge on the oil hole,
and do not rotate the shaft when plastigauge
is in place.
• Mate the lower crankcase with the upper crank-
case, and tighten the crankcase securing bolts
with specified torque value in the indicated
order.
Tightening torque
Initial Final
12-mm
40-50 N·m 60-70 N·m
bolt
(4.0- 5.0 kg-m) (6.0- 7.0 kg-m)
(29.0- 36.0 lb-ft) (43.5- 50.5 lb-ft)
10-mm
25-35 N·m 45-55 N·m
bolt
(2.5- 3.5 kg-m) (4.5- 5.5 kg-m)
(18.0- 25.5 lb-ft) (32.5- 40.0 lb-ft)
• Remove the lower crankcase, and measure the
width of compressed plastigauge in the usual
manner.
Crankshaft journal
oil clearance
Service Limit
0.020 - 0.044 mm
(0.0008- 0.0017 in)
0.080 mm (0.0031 in)
@
@
®
@
ENGINE SERVICING 3-46
®
@