Inspection; Reassembly - Suzuki Madura GV700GL Service Manual

INSPECTION
Inspect the removed parts for the following abnor-
malities.
*
Drive and driven bevel gears damage or wear
*
Improper tooth contact
*
Abnormal noise of bearings
*
Bearing damage or wear.
REASSEMBLY
Reassemble the secondary bevel gears in the
reverse order of disassembly. Pay attention to the
following points.
NOTE:
Before reassembly, thoroughly clean all
parts in cleaning solvent.
SECONDARY DRIVEN BEVEL GEAR
• Install the secondary driven bevel gear pilot
bearing by using the special tool.
09924 - 84520 Bearing installer
• Install a new oil seal by using the special tools.
09924- 74560
09924- 74510
NOTE:
Oil seal installer
Bearing and oil seal
installer handle
The oil seal has a letter mark on its one end,
which must face upside.
• Install the bearing races into the secondary
driven bevel gear housing by using the special
tool.
• After installing the bearing into the secondary
driven bevel gear housing, install a new oil
seal by using the special tool.
• Apply grease to the lip of oil seal.
09913-85210 Bearing installer
99000 - 25030
SUZUKI super grease" A"
SHAFT
DRIVE
4-8