Suzuki Madura GV700GL Service Manual page 205

8-5 ELECTRICAL SYSTEM
IGNITOR UNIT (Checking with Pocket Tester)
• Remove the spark plugs from Nos. 1 and 2 cylinders. Install the respective plug caps and place the
spark plugs on the cylinder head.
• Remove the seat and disconnect the signal generator lead wire coupler from the ignitor.
• Turn the ignition switch to the ON position.
• First, check the No. 1 spark plug.
Connect
8
pin of SUZUKI Pocket Tester (X1
n
range) with Blue lead wire and
EB
pin with Green lead
wire.
The ignitor unit is in good condition if the following is observed:
The moment the test pins are connected the spark plug of No. 1 cylinder sparks.
• Next, check the No. 2 spark plug.
Connect
8
pin of SUZUKI Pocket Tester (X1
n
range) with Yellow lead vvire and
EB
pin with Black
lead wire. No. 2 spark plug sparks when the test pins are connected.
09900. 25002
Pocket tester
NOTE:
This checking presupposes that the ignition coil used for checking is a good one.