Inspection; Reassembly - Suzuki Madura GV700GL Service Manual

4-27 SHAFT DRIVE
INSPECTION
Inspect the removed parts for the following abnor-
malities.
*
Drive and driven bevel gear damage or wear
*
Improper tooth contact
*
Abnormal noise of bearings
*
Bearing damage or wear
REASSEMBLY
Reassemble the final bevel gears in the reverse order
of disassembly. Pay attention to the following
points.
NOTE:
Before reassembly, thoroughly clean all parts
in cleaning solvent.
DRIVE BEVEL GEAR
• Install the bearing races into the final drive
bevel gear housing by usingthe special tool.
09924 - 8451 0 Bearing installer
• Install the bearing onto the final drive bevel
gear shaft by using the special tool.
09913- 80112 Bearing race installer
CAUTION:
When replacing the final drive bevel gear,
replace the final driven bevel gear also, as
they must be replaced together.
• Install the spacer onto the final drive bevel gear
shaft first and then the shims. Use the removed
spacer and shims.
• Install the final drive bevel gear shaft into the
final drive bevel gear housing and then the
bearing from the other side.
NOTE:
Coat the bearing with Hypoid gear oil before
installing.