Water Pump - Suzuki Madura GV700GL Service Manual

3-71 ENGINE SERVICING
• Apply grease to a new 0-ring lightly and hold
the 0-ring in place.
• Install the two positioning pins and install the
water pump to the lower crankcase.
CAUTION:
Make sure that 0-ring is positioned in place.
• Tighten the six bolts to the specified torque.
Tightening torque
7- 11
N-m
(0.7- 1.1 kg-m)
(5.0- 8.0
lb-ft)
• Install the E-ring
CD
and drive pin ®to the
water pump shaft.
• Install the water pump drive sprocket, drive
chain and driven sprocket as shown in the
figure.
NOTE:
Engage the drive sprocket with the idler shaft
drive sprocket.
• Install the E-ring @to the water pump shaft.
• Apply thread lock "1363C" to the drive sprocket
bolt and tighten the bolt to the specified torque.
Hold the idler shaft driven sprocket with the
special tool.
Tightening torque
991 04 . 32050
NOTE:
80-110
N-m
(8.0 - 11.0 kg-m)
(58.0- 79.5
lb-ft)
Thread I ock "1363C''
This bolt has left-hand thread and "L"-mark
on the crown.