Suzuki Madura GV700GL Service Manual page 78

NOTE:
Center journal bearing is wider than R and L
journal bearings, and their parts number are
shown as follows. 12229-05A10-XXX
CRANKSHAFT THRUST CLEARANCE
• With the crankshaft, right-side thrust bearing
and left-side thrust bearing inserted in the upper
crankcase, use a thickness gauge to measure the
thrust clearance on the left side.
NOTE:
Push the crankshaft to the generator side, so
that there is no clearance on the right-side
thrust bearing.
Thrust clearance
Standard
0.045 - 0.1 00
mm
(0.0018- 0.0039
in)
If the thrust clearance exceeds the standard range,
adjust the thrust clearance by the following pro-
cedures.
• Remove the right-side thrust bearing, and mea-
sure its thickness with a micrometer. If the
thickness of the right-side thrust bearing is be-
low standard, replace with a new bearing and
once again perform the thrust clearance mea-
surement listed above, checking to make sure it
is within standards.
Right-side thrust bearing thickness
Standard
2.925 - 2.950 mm
(0.1152 - 0.1161
in)
ENGINE SERVICING 3·48
Crankshaft Upper case Left bearing
Right bearing
¢::J
Push
Front