Suzuki Madura GV700GL Service Manual page 130

4-15 SHAFT DRIVE
• Fit new 0-rings on the secondary gear case as
shown in Fig.
• Coat the 0-ring with grease.
• Fit the secondary drive bevel gear cover on the
secondary gear case, and then apply a small quan-
tity of THREAD LOCK "1363C" to the three
bolts and tighten them to the specified torque.
991 04 - 32050
Tightening torque
Thread lock "1363C"
18-28 N·m
(1.8 - 2.8 kg-m)
(13.0- 20.0 lb-ft)
• Before installing the secondary gear case to the
crankcase, fit the dowel pin and a new gasket to
the crankcase.
• Tighten the secondary gear case bolts to the
specified torque.
CAUTION:
*
Use new gaskets for secondary gear case
and generator cover to prevent oil leakage.
*
When installing the secondary gear case,
apply SUZUKI BOND NO. 1207B to the
threaded parts of bolt
®
to prevent oil
leakage.
18-28 N·m
Tightening torque (1.8- 2.8 kg-m)
(13.0- 20.0 lb-ft)
99104-31140 SUZUKI Bond No. 1207B
NOTE:
After remounting the secondary gear case,
the following service procedures are necessary.
*
Fill the secondary gear case with Hypoid
gear oil.
Specified capacity: 230-250 ml
(7 .8-8.5 US oz)
*
Fill the engine with engine oil.
(See page 2-5)
*
Bleed air after reinstalling the clutch hy-
draulic line. (See page 2-7)
*
Apply BOND NO. 1207B to mating surface
of swingarm and final gear case.
(See page 4-36)
*
Adjust the rear brake. (See page 2-12)