Suzuki Madura GV700GL Service Manual page 188

6-19 FUEL AND LUBRICATION SYSTEM
• Install the four carburetor assemblies to the
engine assembly as shown in the figure and
tighten the intake pipe clamps securely.
• In this condition tighten all the plate screws
properly.
CAUTION:
When tightening carburetor plate screws,
make sure to follow the above steps. Failure
to do so cause imbalance of carburetors.
• When installing the front plate screws, apply
thread lock cement to the screw thread.
99000 - 32040
Thread lock cement
• Then remove the carburetor assembly from the
engine assembly.
• Set each throttle valve in such a way that its
top end
®
meets the foremost bypass @.
• Balance the front and rear carburetors by
turning the balance screws
CD.