State-Refresh-Hoplimit (Ipv6 Pim View); State-Refresh-Interval (Ipv6 Pim View) - HP 5900 Series Command Reference Manual

[Sysname-acl6-basic-2000] rule permit source ff3e
[Sysname-acl6-basic-2000] quit
[Sysname] ipv6 pim
[Sysname-pim6] ssm-policy 2000
state- refresh-hoplimit (IPv6 PIM view)
Use state-refresh-hoplimit to set the hop limit for state refresh messages.
Use undo state-refresh-hoplimit to restore the default.
Syntax
state-refresh-hoplimit hoplimit-value
undo state-refr
Default
The hop limit fo
Views
IPv6 PIM view
Predefined user roles
network-admin
Paramete rs
hoplimit-value: Sets a h
Examples
# Set the ho
<Sysname> system-view
[Sysname] ipv6 pim
[Sysname-pim6] state-refresh-hoplimit
Related commands
ipv6 pim state-refresh-capable
•

state-refresh-interval (IPv6 PIM view)

•
• state-refresh-rate-limit (IPv6 PIM view)
state- refresh-interval (IPv6 PIM view)
Use state-refresh-interval to set the state refresh interval.
Use undo state-refresh-interval to restore the default.
Syntax
state-refresh-interval interval
undo state-refr
Default
The state refresh in
esh-hoplimit
r state refresh messages is 255.
op limit for state refresh messages, in the range of 1 to 255.
p limit for state refresh messages to 45 on the public network.
esh-interval
terval is 60 seconds.
:0:8192:: 96
45
342