HP 5900 Series Command Reference Manual page 277

Use undo ipv6 multicast boundary to delete the specified IPv6 multicast forwarding boundary.
Syntax
ipv6 multicast boundary { ipv6-gro
organization-local | site-local } }
undo ipv6 multicast boundary { ipv6-group-ad
| global | organization-local | site-local } }
Default
No IPv6 multicast forwarding boundary is configured.
Views
Interface view
Predefine d user roles
netw ork-admin
Paramete rs
ipv6-group-address: Specifies an IPv6 multicast group
"y" represent any hexadecimal numbers from 0 to F.
prefix-length: Specifies an address prefix length in the range of 8 to 128
all: Specifies all IPv6 multicast boundaries configured on the interface.
scope-id: Specifies the ID of an admin-scope zo
scope field in the IPv6 multicast group address.
admin-local: Specifies the scope zone as admin-local, which has a scope
global: Specifies the scope zone as global, which has a scope ID of 14.
organization-local: Specifies the scope zone as organization-local, which has a s
site-local: Specifies the scope zone as site-local, which has a scope ID of 5.
Usage gu idelines
You do not need to enable IPv6 multicast routing before executing this command.
A multicast forwarding boundary sets the boundary condition for the IPv6 multicast groups in the
specified address range. If the destinatio
condition, the packet is not forwarded.
An interface can act as a forwarding boundary for multiple IPv6 multicast groups in different address
ranges. You can implement this by using this command on the interface for each multicast address range.
These multicas
previous one.
Assume that Set A and Set B are both IPv6 multicast forwarding boundary sets with different address
ranges, and that B is a
B, B will be removed.
Examples
# Configure VLAN
of FF03::/16.
<Sysname> system-view
[Sysname] interface vlan-interface 100
up-address prefix-length | scope { scope-id | admin-local | global |
t groups must be in the same scope. The latest configuration of a scope overwrites the
subset of A. If B is configured after A, A still takes effect. If A is configured after
-interface 100 to be the forwarding boundary of the IPv6 multicast groups in the range
dress prefix-length| all | scope { scope-id | admin-local
address in the range of FFxy::/16, where "x" and
ne, in the range of 3 to 15, which is identified by the
n address of an IPv6 multicast packet matches the set boundary
267
.
ID of 4.
cope ID of 8.