Timer Hello (Ipv6 Pim View) - HP 5900 Series Command Reference Manual

You can configure multiple static RPs by using this command multiple times. However, if you specify the
same static RP address or reference the same ACL in the commands, the most recent configuration takes
effect. If you configure multiple static RPs for the same IPv6 multicast group, the static RP with the highest
IPv6 address is used.
Examples
# On the public network, configure the interface with the IPv6 address o
IPv6 multicast groups FF03::101/64,
<Sysname> system-vie
[Sysname] acl ipv6 number 2001
[Sysname-a
[Sysname-acl6-basic-20
[Sysname] ipv6 pim
[Sysname-pim6] static-rp 2001::2 2
Related commands
display ipv6 pim rp-info

timer hello (IPv6 PIM view)

Use timer hello to se
Use undo timer he
Syntax
timer hello interval
undo timer hello
Default
The global hel
Views
IPv6 PIM view
Predefine d user roles
network-admin
Parameters
interval: Sets a hello interval in the range of 0 to 18000 seconds. If you set the value to 0 seconds, the
interface does not send hello messages.
Usage guid elines
You can set the hello interval for all interfaces in IPv6 PIM view or fo
view. The configuration made in inter
view.
Examples
# Set the glo
<Sysname> system-v
[Sysname] ipv6 pim
[Sysname-pim6] timer hello 40
w
cl6-basic-2001] rule permit source ff03::101 64
01] quit
t the global hello interval.
llo to restore the default.
lo interval is 30 seconds.
bal hello interval to 40 seconds on the public network.
iew
and give priority to this static RP.
001 preferred
face view takes priority over the c
345
f 2001::2 as a static RP for the
r the current interface in interface
onfiguration made in IPv6 PIM