Register-Whole-Checksum (Ipv6 Pim View) - HP 5900 Series Command Reference Manual

Predefined user roles
network-admin
Paramete rs
acl6-number: Specifies an IPv6 advanced ACL number in the range of 3000 to 3999.
Usage guide lines
In an IPv6 advanced ACL, the source and destination keywords match the source address and multicast
group address in register messages, respectively.
If you specify the vpn-insta
parameters except the time-range keyw
Examples
# On the public network, configure a
sources on the subnet o
<Sysname> system-view
[Sysname] acl ipv6 number 3000
[Sysname-acl6-adv-3000] rule permit ipv6 source 3:1::
[Sysname-acl6-adv-3000] quit
[Sysname] ipv6 pim
[Sysname-pim6] r
regis ter-whole-checksum (IPv6 PIM view)
Use register-whole-checksu
register message.
Use undo register-whole-checksum to restore the default.
Syntax
register-whole-checksum
undo register-w
Default
The switch calcu
Views
IPv6 PIM view
Predefine d user rol es
network-admin
Examples
# On the public network, configure the switch
message.
<Sysname> system-view
[Sysname] ipv6 pim
[Sysname-pim6] register-whole-checksum
nce keyword in an ACL rule, the rule does not take effect. The other optional
n IPv6 PIM register policy to accept the register messages from the
f 3:1::/64 to the groups on the subnet of FF0E:13::/64.
egister-policy 3000
m to configure the switch to calculate the checksum based on an entire
hole-checksum
lates the checksum based on the register message header.
ord and the fragment keyword in the ACL rules are ignored.
to calculate the checksum based on an entire register
338
64 destination ff0e:13:: 64