Mld-Snooping Group-Policy - HP 5900 Series Command Reference Manual

Default
The default setting is 4294967295.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
limit: Sets the maximum number of multicast groups that a port can join, in the range of 0 to
4294967295.
vlan vlan-list: Specifies a space-separated list of up to 10 VLAN items. Each item specifies a VLAN by its
ID or a range of VLANs in the form of start-vlan-id to end-vlan-id. The value range for the VLAN ID is 1
to 4094. If you do not specify a VLAN, the command applies to all VLANs.
Usage guidelines
This command takes effect only on the IPv6 multicast groups that a port joins dynamically.
Examples
# Set the maximum number of IPv6 multicast groups that Ten-GigabitEthernet 1/0/1 in VLAN 2 can join
to 10.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] mld-snooping group-limit 10 vlan 2

mld-snooping group-policy

Use mld-snooping group-policy to configure an IPv6 multicast group policy on a port to control the IPv6
multicast groups that the receiver hosts attached to the port can join.
Use undo mld-snooping group-policy to remove the IPv6 multicast group policy on a port.
Syntax
mld-snooping group-policy acl6-number [ vlan vlan-list ]
undo mld-snooping group-policy [ vlan vlan-list ]
Default
IPv6 multicast group policies are not configured on a port, and the hosts attached to the port can join
IPv6 multicast groups.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
acl6-number: Specifies an IPv6 basic or advanced ACL by its number in the range of 2000 to 3999.
Receiver hosts can join only IPv6 multicast groups that the ACL permits. If the ACL does not exist or the
ACL does not contain valid rules, receiver hosts cannot join IPv6 multicast groups.
218