HP 5900 Series Command Reference Manual page 130

Table 37 Command output
Field
Current state
Line protocol state
Description
Bandwidth
Maximum Transmit Unit
Internet protocol processing
Physical
Last 300 seconds input rate
Last 300 seconds output rate
Input
Output
Brief information on interface(s)
under route mode
Link: ADM - administratively down;
Stby - standby
Protocol: (s) - spoofing
Protocol
Main IP
Cause
Description
Physical state of the register-tunnel interface. This field always displays
UP.
Link state of the register-tunnel interface. This field always displays
DOWN.
Description of the register-tunnel interface. It is not configurable.
Expected bandwidth of the register-tunnel interface. It is not configurable.
MTU of the register-tunnel interface. It is not configurable.
IP protocol processing capability. This field always displays disabled.
Physical type of the register-tunnel interface. This field always displays
Unknown.
Average incoming rate in the last 300 seconds. This field always displays
0.
Average outgoing rate in the last 300 seconds. This field always displays
0.
Number of incoming packets, incoming bytes, and discarded packets.
This field always displays 0.
Number of outgoing packets, outgoing bytes, and discarded packets.
This field always displays 0.
Brief information about Layer 3 interfaces.
Physical state of the interface:
•
UP—The interface is physically up.
•
DOWN—The interface is physically down.
•
ADM—The interface has been administratively shut down. To recover
its physical state, use the undo shutdown command.
•
Stby—The interface is a backup interface. To display information
about the primary interface, use the display interface-backup
command.
If the Protocol field contains "(s)", it means one of the following
conditions:
•
The data link protocol state of the interface is up, but no link is present
on the interface.
•
The link is created on demand.
Typically, null interfaces or loopback interfaces have this attribute.
Protocol connection state of the interface. This field always displays
double hyphens (--).
IP address of the interface. This field always displays double hyphens (--).
Causes why the physical state of the interface is down. This field always
displays Not connected.
120