Dot1X Max-User - HP 3600 v2 Series Command Reference Manual

dot1x max-user

Syntax
In system view:
dot1x max-user user-number [ interface interface-list ]
undo dot1x max-user [ interface interface-list ]
In Ethernet interface view:
dot1x max-user user-number
undo dot1x max-user
View
System view, Ethernet interface view
Default level
2: System level
Parameters
user-number: Specifies the maximum number of concurrent 802.1X users on a port. The value is in the
range of 1 to 2048.
interface interface-list: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list argument is in the format of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } & <1- 1 0>, where interface-type represents the port type,
interface-number represents the port number, and & <1- 1 0> means that you can provide up to 10 ports
or port ranges. The start port number must be smaller than the end number and the two ports must be of
the same type.
Description
Use the dot1x max-user command to set the maximum number of concurrent 802.1X users on a port.
Use the undo dot1x max-user command to restore the default.
By default, the maximum number of concurrent 802.1X users on a port is 2048.
In system view:
• If you do not specify the interface-list argument, the command applies to all ports.
If you specify the interface-list argument, the command applies to the specified ports.
•
In Ethernet interface view, the interface-list argument is not available and the command applies to only
the Ethernet port.
Related commands: display dot1x.
Examples
# Set the maximum number of concurrent 802.1X users on port Ethernet 1/0/1 to 32.
<Sysname> system-view
[Sysname] dot1x max-user 32 interface ethernet 1/0/1
Or
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] dot1x max-user 32
112