Idle-Cut Enable - HP 3600 v2 Series Command Reference Manual

To delete the ISP domain that is used as the default ISP domain, you must change it to a non-default ISP
domain first by using the domain default disable command.
Related commands: domain, state, and display domain.
Examples
# Create a new ISP domain named test, and configure it as the default ISP domain.
<Sysname> system-view
[Sysname] domain test
[Sysname-isp-test] quit
[Sysname] domain default enable test

idle-cut enable

Syntax
idle-cut enable minute [ flow ]
undo idle-cut enable
View
ISP domain view
Default level
2: System level
Parameters
minute: Idle timeout period, in the range of 1 to 600 minutes.
flow: Minimum traffic during the idle timeout period, which is in the range of 1 to 10240000 bytes and
defaults to 10240.
Description
Use the idle-cut enable command to enable the idle cut function and set the relevant parameters. With
the idle cut function enabled for a domain, the switch checks the traffic of each online user in the domain
at the idle timeout interval, and logs out any user in the domain whose traffic during the idle timeout
period is less than the specified minimum traffic.
Use the undo idle-cut enable command to restore the default.
By default, the function is disabled.
You can also set the idle timeout period on the server to make the server log out users whose traffic during
the idle timeout period is less than 10240 bytes, but your setting on the server takes effect only when you
disable the idle cut function on the switch.
Related commands: domain.
Examples
# Enable the idle cut function and set the idle timeout period to 50 minutes and the traffic threshold to
1024 bytes for ISP domain test.
<Sysname> system-view
[Sysname] domain test
[Sysname-isp-test] idle-cut enable 50 1024
23