Ipv6 Verify Source - HP 3600 v2 Series Command Reference Manual

Description
Use the ipv6 source binding command to configure a static IPv6 source guard binding entry on a port.
Use the undo ipv6 source binding command to delete a static IPv6 source guard binding entry from a
port.
By default, no static IPv6 binding entry exists on a port.
You cannot configure the same static binding entry repeatedly on one port, but you can configure the
same static entry on different ports.
You cannot configure a static binding entry on a port that is in an aggregation group or a service
loopback group.
Related commands: display ipv6 source binding static.
Examples
# Configure a static IPv6 binding entry (IP+MAC binding) on port Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1]
0002-0002-0002

ipv6 verify source

Syntax
ipv6 verify source { ipv6-address | ipv6-address mac-address | mac-address }
undo ipv6 verify source
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
Parameters
ipv6-address: Binds source IPv6 addresses to the port.
ipv6-address mac-address: Binds source IPv6 addresses and MAC addresses to the port.
mac-address: Binds source MAC addresses to the port.
Description
Use the ipv6 verify source command to enable the IPv6 source guard function on a port and specify the
elements to be included in the port's dynamic binding entries.
Use the undo ipv6 verify source command to restore the default.
By default, the IPv6 source guard binding function is disabled on a port.
After you configure the IPv6 source guard function on a port, the IPv6 source guard function dynamically
generates IPv6 source guard entries based on the DHCPv6 snooping entries or ND snooping entries,
and all static IPv6 source guard binding entries become effective.
You cannot configure the IPv6 source guard binding function on a port that is in an aggregation group
or a service loopback group.
ipv6 source binding
297
ipv6-address 2001::1 mac-address