HP 3600 v2 Series Command Reference Manual page 325

undo arp filter binding ip-address
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
ip-address: Specifies the permitted sender IP address.
mac-address: Specifies the permitted sender MAC address.
Description
Use the arp filter binding command to configure an ARP filtering entry. If the sender IP and MAC
addresses of an ARP packet match an ARP filtering entry, the ARP packet is permitted. If not, it is
discarded.
Use the undo arp filter binding command to remove an ARP filtering entry.
By default, no ARP filtering entry is configured.
NOTE:
You can configure up to eight ARP filtering entries on a port.
You cannot configure both the arp filter source and arp filter binding commands on a port.
Examples
# Configure an ARP filtering entry with permitted sender IP address 1.1.1.1 and MAC address 2-2-2.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] arp filter binding 1.1.1.1 2-2-2
315