Encapsulation-Mode - HP 3600 v2 Series Command Reference Manual

queue is full: 0
authentication has failed: 0
wrong length: 0
replay packet: 0
packet too long: 0
wrong SA: 0
Table 39 Output description
Field
Connection ID
input/output security packets
input/output security bytes
input/output dropped security packets
dropped security packet detail
not enough memory
can't find SA
queue is full
authentication has failed
wrong length
replay packet
packet too long
wrong SA

encapsulation-mode

Syntax
encapsulation-mode { transport | tunnel }
undo encapsulation-mode
View
IPsec proposal view
Default level
2: System level
Parameters
transport: Uses transport mode.
tunnel: Uses tunnel mode.
Description
Use the encapsulation-mode command to set the encapsulation mode that the security protocol uses to
encapsulate IP packets.
Description
ID of the tunnel
Counts of inbound and outbound IPsec protected packets
Counts of inbound and outbound IPsec protected bytes
Counts of inbound and outbound IPsec protected packets that are
discarded by the switch
Detailed information about inbound/outbound packets that get
dropped
Number of packets dropped due to lack of memory
Number of packets dropped due to finding no security association
Number of packets dropped due to full queues
Number of packets dropped due to authentication failure
Number of packets dropped due to wrong packet length
Number of packets replayed
Number of packets dropped due to excessive packet length
Number of packets dropped due to improper SA
238