Habp Timer - HP 3600 v2 Series Command Reference Manual

Parameters
vlan-id: Specifies the ID of the VLAN in which HABP packets are to be transmitted, in the range of 1 to
4094.
Description
Use the habp server vlan command to configure HABP to work in server mode and specify the VLAN in
which HABP packets are to be transmitted.
Use the undo habp server command to configure HABP to work in the default mode.
By default, HABP works in client mode.
In a cluster, if a member switch with 802.1X authentication or MAC authentication enabled is attached
with some other member switches of the cluster, you also need to configure HABP server on this device.
Otherwise, the cluster management device will not be able to manage the devices attached to this
member switch. For information about the cluster function, see Network Management and Monitoring
Configuration Guide.
Examples
# Configure HABP to work in server mode and specify the VLAN for HABP packets as VLAN 2.
<Sysname> system-view
[Sysname] habp server vlan 2

habp timer

Syntax
habp timer interval
undo habp timer
View
System view
Default level
2: System level
Parameters
interval: Specifies the interval (in seconds) at which the switch sends HABP request packets, in the range
of 5 to 600.
Description
Use the habp timer command to set the interval at which the switch sends HABP request packets.
Use the undo habp timer command to restore the default.
The default interval is 20 seconds.
This command is required only on the HABP server.
Examples
# Set the interval at which the switch sends HABP request packets to 50 seconds.
<Sysname> system-view
[Sysname] habp timer 50
194