Arp Detection Trust - HP 3600 v2 Series Command Reference Manual

View
VLAN view
Default level
2: System level
Parameters
None
Description
Use the arp detection enable command to enable ARP detection for the VLAN.
Use the undo arp detection enable command to restore the default.
By default, ARP detection is disabled for a VLAN.
Examples
# Enable ARP detection for VLAN 1.
<Sysname> system-view
[Sysname] vlan 1
[Sysname-Vlan1] arp detection enable

arp detection trust

Syntax
arp detection trust
undo arp detection trust
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
None
Description
Use the arp detection trust command to configure the port as an ARP trusted port.
Use the undo arp detection trust command to restore the default.
By default, the port is an ARP untrusted port.
Examples
# Configure layer 2 Ethernet port Ethernet 1/0/1 as an ARP trusted port.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] arp detection trust
308