Standards Supported By These Cables; Mx150 - Juniper MX150 Hardware Manual

Table 23: SFP+ Direct Attach Copper Cable Specifications (continued)
Model Number Specification
EX-SFP-10GE-DAC-5M Rate
Connector type
Supply voltage
Power consumption (per end)
Storage temperature
Cable type
Wire AWG
Minimum cable bend radius
Cable characteristic impedance
Crosstalk between pairs
Time delay
Length

Standards Supported by These Cables

Related
Documentation
Cable Specifications for Console and Management Connections for the MX150
Copyright © 2017, Juniper Networks, Inc.
The cables comply with the following standards:
SFP mechanical standard SFF-843—see
Electrical interface standard SFF-8432—see
SFP+ Multi-Source Alliance (MSA) standards
Pluggable Transceivers Supported on MX150 on page 37
Installing a Transceiver in an MX150 on page 103
Removing a Transceiver from an MX150 on page 101
Table 24 on page 66 lists the specifications for the cables that connect the MX150 to a
management device.
Chapter 8: Transceiver and Cable Specifications
Value
10-Gbps full-duplex serial transmission
SFP+ passive Twinax cable assembly
3.3 V
0.57 W
–40° C through 85° C
Twinax
24 AWG
1 in. (2.54 cm)
100 ohms
2% maximum
1.31 nsec/ft
5 m
ftp://ftp.seagate.com/sff/SFF-8431.PDF
ftp://ftp.seagate.com/sff/SFF-8432.PDF
.
.
65