Advertisement
CHAPTER 14
Removing the MX150
Powering Off an MX150
Copyright © 2017, Juniper Networks, Inc.
Powering Off an MX150 on page 97
Removing an MX150 from a Rack or Cabinet on page 99
If you need to power off the MX150, follow the procedure in this topic.
Before you power off the device:
Ensure that you understand how to prevent electrostatic discharge damage. See
"Prevention of Electrostatic Discharge Damage" on page
Ensure that you do not need to forward traffic through the device.
Ensure that you have the following parts and tools available to power off the device:
An ESD grounding strap
An external management device such as a PC
A cable to connect the external management device to the console port (
management port (
MGMT
To power off the device:
Connect the management device (such as a PC) to the console (
1.
management (
) port on the device:
MGMT
For connecting a management device to the console port, see
to a Management Console" on page
For connecting a management device to the management port, see
an MX150 to a Network for Out-of-Band Management" on page 89
From the PC connected to the device, issue the following operational mode CLI
2.
command:
user@host> request system halt
This command shuts down the device gracefully and preserves system state
information. A message displays on the console confirming that the operating system
has halted.
) on the device
90.
151.
CON
) or
CON
) port or the
"Connecting an MX150
"Connecting
97
Advertisement
Chapters
