Juniper MX150 Hardware Manual page 110

MX150 3D Universal Edge Router Hardware Guide
Related
Documentation
94
(Optional) Configure the name of the device. If the name includes spaces, enclose
5.
the name in quotation marks (" ").
[edit]
root@host# set system host-name host-name
Configure the IP address and prefix length for the device management interface.
6.
[edit]
root@host# set interfaces fxp0 unit 0 family inet address address/prefix-length
fxp0 is the management interface.
To configure an IPV6 address, run the
address address v6_address
NOTE: fxp0
Configure the default gateway.
7.
[edit]
root@host# set routing-options static route default next-hop address
Enable the SSH service.
8.
[edit]
root@host# set system services ssh
Enable the Telnet service.
9.
[edit]
root@host# set system services telnet
Commit the configuration to activate it on the device.
10.
[edit]
root@host# commit
Installing and Connecting an MX150 on page 77
root@host# set interface fxp0 family inet6
.
is found on the front panel of the MX150 device.
Copyright © 2017, Juniper Networks, Inc.